Access Keys:
Skip to content (Access Key - 0)

All content with label howto.
Related Labels: linkageerror, linkage, pending_finishupdate, loading, classloader, memory-leaks, slee-programming, classcastexception, classloading, slee_1_1, debugging, classnotfoundexception, ss7, pending_approval, loader, class, noclassdeffounderror

How do I use Rhino's Rate Limiting in my RA or SBB? (Dev Portal)
Author matthewl 2.1 Below are basic concepts about rate limiting, a general overview of how developers can use the rate limiting system, and a set of instructions for performing specific rate limiting tasks. Rate limiting concepts Rate limiting ...
How do I use SLEE Initial Event Selection? (Dev Portal)
Introduction The JAIN SLEE Initial Event Selection mechanism allows developers to flexibly control how events trigger services. For example, a developer can specify that a service is only triggered when a certain parameter is present in the event, or only if the event is addressed ...
Other labels: slee-programming
How Do I Use Stateful Alarms in SLEE 1.1 (Dev Portal)
Introduction Alarm management has changed significantly with Rhino 2.0. In SLEE 1.0, Alarms were stateless and the Alarm Facility was used by SBBs (and other components as determined by the SLEE vendor) to generate alarm notifications for management clients. In SLEE 1.1, Alarms ...
Other labels: slee_1_1
How do I Use the Event Context in SLEE 1.1 (Dev Portal)
Introduction This document provides an overview of the Event Context introduced in Rhino 2.0, how it can be used, and why you might want to do so. Event Context Overview Every event fired in a JAIN SLEE 1.1 SLEE has ...
Other labels: slee_1_1
How Do I Use the New SLEE 1.1 CMP Types (Dev Portal)
Introduction This guide explains the new CMP types supported by SLEE 1.1 The SLEE architecture defines how a service can be composed of a series of SBB components. Each SBB component apart from defining e.g. the event types received and fired ...
Other labels: slee_1_1
How should SLEE applications persist data? (Dev Portal)
Author bsd Profiles or a relational database? This is probably one of the most common design questions among JSLEE architects. The answer depends on many variables, including: the amount of data, the complexity of the data model, the data usage, the performance requirements, and the cost restrictions ...
How-to Configure File Appenders (Dev Portal)
Author nick Introduction The excerpt is a short precis of the article content. It can be the first few sentences of the introduction, in which case remove the hidden=true parameter above. This article describes how to setup and configure file appenders in Rhino, and how to use ...
How to decode Lock IDs in Rhino logs (Dev Portal)
Author davidp Investigating lock timeouts Sometimes you may see reports in Rhino logs of lock timeouts. For example this may happen under load. The log messages refer to a lock ID. The lock ID contains potentially useful information ...
Other labels: debugging, slee-programming
How to diagnose a JVM crash on Rhino? (Dev Portal)
Author samuel Introduction The excerpt is a short precis of the article content. It can be the first few sentences of the introduction, in which case remove the hidden=true parameter above. This document provides information and guidance on some procedures for diagnose a JVM crash on Rhino ...
Other labels: debugging, slee-programming
How-to Guides (Dev Portal)
Articles about the Rhino application server Search the Howto Guides
Adaptavist Theme Builder Powered by Atlassian Confluence